Re: 1/48 Italeri Tornado F.3 ADV
Posted: Thu Apr 02, 2015 2:51 pm
Thanks Mostrich!mostrich wrote:Up to a fast and impressive start.
Following...
Page 2 of 4
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Thu Apr 02, 2015 3:11 pm
The canopies fit perfectly. No issues there at all. They're not glued in yet.
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Thu Apr 02, 2015 4:38 pm
Excellent fit of the parts! No filler used yet?
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Thu Apr 02, 2015 5:09 pm
Thanks guys. There's some areas that are gonna need some filler and sanding. Especially on the bottom at the front. The intakes are gonna need a lot of work as well.
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Thu Apr 02, 2015 5:50 pm
I like that red tail, too.
great job on teh pit.
is the nose/fuse assembly just a butt join or are there tabs that slot into place?
great job on teh pit.
is the nose/fuse assembly just a butt join or are there tabs that slot into place?
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Fri Apr 03, 2015 11:19 am
Looking real good so far Doc!
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Sun Apr 05, 2015 11:56 am
Great to see a Tornado being built, nice work so far, and a good choice of scheme.
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Mon Apr 06, 2015 12:27 pm
Thanks all!
@Owl- There's tabs at the bottom but they don't help much.
I always try and find a special scheme, CAG jet, or something different so that it's not just a grey jet.
@Owl- There's tabs at the bottom but they don't help much.
I always try and find a special scheme, CAG jet, or something different so that it's not just a grey jet.
Re: 1/48 Italeri Tornado F.3 ADV
Posted: Mon Apr 06, 2015 12:28 pm
Intakes are done. Just need to clean them up.
