SPA Modeler

For related offbeat thoughtful entertainment purposes...

https://www.cracked.com/article_18719_t ... -wars.html

Wow! This is gonna be awesome!

Thankee kindly. There is so much reference to unpack - a lot of it resides in my cranium - I hope I am providing enough of an introduction. Folks, I need your assistance either sourcing the 1/24 pilot or equivalent for the cockpit. Here are a few more Floki images!

Stikpusher wrote:For related offbeat thoughtful entertainment purposes...

https://www.cracked.com/article_18719_t ... -wars.html

That sir is one hilarious article

Bruce, that thing is so cool.

With all due respect to all our mods, supervisors, forum members, passerby, etc, a four letter word is incoming! I am going to paint the shit outta this. Happy Easter.

Oh, and this fella was 8 bucks on eBay.



ILM original.

He should be easily modded into a tie pilot

Paint him up to your hearts desire Bruce! But go wash your mouth out with some soap for that language...

Thanks, Clint and Carlos. I hope you both have a Happy Easter!

Wow... And wow. I am on this show too. I am really interested how parts will fit while they are printed in different processes.

Marius, welcome aboard! I’m curious as well how to best adhere everything together once printed.



Tolerances between resin and filament appear to be fair, although Clint is certainly much more versed in a direct reply. I believe resin was chosen specifically for the level of detail. My other concern is sanding the command ball. I have very little experience with sanding a 3D printed piece whose outer shape must remain round.