Re: 1/48 B-25J Mitchell
Posted: Fri Aug 25, 2017 9:58 am
Yes...........and no.Stikpusher wrote:Is this going to be in a NMF?
Page 14 of 14
Re: 1/48 B-25J Mitchell
Posted: Fri Aug 25, 2017 5:29 pm
Ok... I think I know where you're going with this one...
Re: 1/48 B-25J Mitchell
Posted: Fri Aug 25, 2017 8:41 pm
Time for some engine work!
Re: 1/48 B-25J Mitchell
Posted: Tue Sep 05, 2017 8:28 am
The Mitchell is looking good in her black base. The PE wiring harness for the engine is a good addition. I like to give the harness a few coats of brushed-on paint to remove that "flat" look.
Re: 1/48 B-25J Mitchell
Posted: Wed Sep 06, 2017 12:53 pm
What color would you use?jkim wrote:The Mitchell is looking good in her black base. The PE wiring harness for the engine is a good addition. I like to give the harness a few coats of brushed-on paint to remove that "flat" look.
Re: 1/48 B-25J Mitchell
Posted: Thu Sep 07, 2017 8:42 am
Tamiya Red Brown XF-64 is what I normally use for engine ignition wiring.Medicman71 wrote:What color would you use?jkim wrote:The Mitchell is looking good in her black base. The PE wiring harness for the engine is a good addition. I like to give the harness a few coats of brushed-on paint to remove that "flat" look.
Re: 1/48 B-25J Mitchell
Posted: Thu Sep 07, 2017 8:46 am
Medicman71 wrote:Yes...........and no.Stikpusher wrote:Is this going to be in a NMF?
Stikpusher wrote:Ok... I think I know where you're going with this one...
IntriguingRe: 1/48 B-25J Mitchell
Posted: Fri Sep 08, 2017 10:50 am
The nose guns snap off yet? I hope not...
I hope not...Re: 1/48 B-25J Mitchell
Posted: Thu Sep 14, 2017 12:03 pm
Nope not yet. One waist gun might be close though.