SPA Modeler

Posted: **Wed May 30, 2018 9:39 am**

After getting off a 24 hr shift, it's time to get back to work on the A-10.

I've been fighting with the ammo feed cover. Not a lot of contact points to glue it down.

Posted: **Wed May 30, 2018 11:09 am**

24HR Shift!?!?! Damn you EMS guys put in the hours! (and thanks for that BTW).

The A-10 is looking great - I'm loving this additional PE.

Posted: **Wed May 30, 2018 11:49 am**

That's looking good Medic. I hope you get the ammo feed cover issue sorted out man. Will be watching / rooting you on.

Posted: **Wed May 30, 2018 12:43 pm**

Thanks guys!

Posted: **Wed May 30, 2018 2:00 pm**

Work on the gun area continues. Had to do something with that ugly strip at the front of the bay. Cut it out and added a piece of evergreen strip that was the perfect width. It's glued in place, just need to trim a little on the outside.

Posted: **Wed May 30, 2018 3:28 pm**

Got the piece faired in and super glue in the gap (right side of gun bay as looking at the pic).

Posted: **Thu May 31, 2018 3:06 pm**

Impressive work! That is a tremendous improvement on the model. Way to go!

Posted: **Fri Jun 01, 2018 11:45 am**

Thanks Duke!

Weapons work.

Posted: **Fri Jun 01, 2018 3:16 pm**

PE on the missiles... oh my!

Posted: **Fri Jun 01, 2018 3:43 pm**

SPA Modeler

1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10

Re: 1/48 Hobby Boss A-10