Page 15 of 17

Re: Commission Build for Bruce Cooper

Posted: Tue Feb 12, 2019 4:12 pm
by speedgraflex
Mark, let me know when you want Kit and Guns.

Re: Commission Build for Bruce Cooper

Posted: Tue Feb 12, 2019 4:18 pm
by Duke Maddog
Thanks Bruce. I'll do a few things that I can while I wait for the new kit and parts.

Re: Commission Build for Bruce Cooper

Posted: Tue Feb 12, 2019 4:20 pm
by Duke Maddog
speedgraflex wrote:Mark, let me know when you want Kit and Guns.

As soon as possible. I really do want to finish this for you. I personally feel I've made you wait far too long.

Re: Commission Build for Bruce Cooper

Posted: Wed Feb 13, 2019 3:10 pm
by speedgraflex
Dropped the box off at my post office an hour ago, Mark... on its way!

Re: Commission Build for Bruce Cooper

Posted: Fri Feb 15, 2019 2:17 pm
by Duke Maddog
Thanks Bruce! As of yesterday the Eagle has landed. I'll be getting started on this again this coming week.

Re: Commission Build for Bruce Cooper

Posted: Fri Feb 15, 2019 3:39 pm
by speedgraflex
Good luck! TGIF!

Re: Commission Build for Bruce Cooper

Posted: Fri Feb 15, 2019 4:33 pm
by KSaarni
The build is back on track !

- Kari

Re: Commission Build for Bruce Cooper

Posted: Sat Feb 16, 2019 8:24 am
by Stikpusher
Duke Maddog wrote:Thanks Bruce! As of yesterday the Eagle has landed. I'll be getting started on this again this coming week.
That could go one of two ways... in the 1977 film, “The Eagle Has Landed”, after Col Radl passes on this code phrase to Reichsführer Himmler, things slowly go awry for the “eagle” folks... and do not end well for most of them. :headslap: A great film if you have never seen it.
On the other hand, hardly a human alive on earth has not heard that same phrase spoke by Neil Armstrong that turned out much better. Although in reality that was a very near thing on the way down. :hmm:

Re: Commission Build for Bruce Cooper

Posted: Sat Feb 16, 2019 10:30 am
by speedgraflex
70mm / IMAX / Feb 28


Re: Commission Build for Bruce Cooper

Posted: Sat Feb 16, 2019 10:46 am
by Stikpusher
:hmm:

Oh my!