SPA Modeler

Last night mesked black areas after the engines zone with black grey





..And here the mouth :
with few other decals. Using also a begermot sheet about Hip stencils, lots to put in the next sessions. Obliviously i used two glossy layers before
Insigna and numbers are posing with real pictures, instructions reports wrong places to put them.







At the next with the other stencils

Very interesting markings on this one!

Is that a tongue hanging out of the mouth?

Stikpusher wrote:Is that a tongue hanging out of the mouth?

Yes

Almost all stencils (from begermot Hip stencil sheet) are placed










Now left few to put and refine the details.
At the next

That's looking real good there BSY! Quite colorful too!

Sweet job. That is a great looking helicopter.

Thanks


Now rotor affairs:
A mix to match the rotor blades colorand masking aluminium on the front.






during the masking i recalled that i have another hip under wip and rotor colors are the same..



then , not in picture i give it five layers of the same grey/green color

At the next!

That is not a shark mouth, that is a dogs mouth with that tongue hanging out!

interesting, never considered about dogmouth

There was an O-1 Birddog in Vietnam that had a similar dog mouth painted on... for obvious reasons.