SPA Modeler

Thanks Bruce! I do enjoy the look of Luftwaffe splinter camo, but it usually takes two to three sessions to get those edges and corners right when done freehand…

The past few days I got the upper rear fuselage glued in place, some seam work done (but not enough to quite fix them without remove surface detail), and lastly the horizontal stabilizers glued in place along with the brace struts. I also did some touch up paint work, as well as getting the canopy dipped in a Future bath…






I now need to mask of the canopy panes and paint the frame work, finish painting up Herr Möldy Wiener among a few other bits of detail painting, do a tad bit of tough up paint work on the tail around the brace struts, but then it will be ready for a gloss coat and decals…

Thanks Bruce!

I got the decals applied this afternoon… but I had not stored them properly in a zip lock bag so they did not come out 100%…



I have to do so repair touch up work on a few of them.

Thanks Bruce! I’ll be breaking out the paint pens for the decals touch up/repair work. The wingtop cross closest to the camera is the one that came out the worst, so once that one is fixed, the rest will be far less extensive to fix. Revell decals are not too reliable to begin with, and having these stored for 15+ years in the open in a garage, with no protection from temperature and humidity variations probably sealed their fate. I have to be more cognizant of that on some of my other old projects like this. I may be shelling out big bucks on replacement decals for similar projects if I do not.
,

Bruce, I'm not sure how I would describe my technique, but perhaps as akin to using colored pencils. I use the tip for small areas, but then angle the paint pen on its side as if sharpening the point for larger areas and those needling a straight line/edge. In this case I used some Gundam fine tip paint pens, since all I needed was black and white, and those colors were in one of the sets that I have.

here are before and after photos of my efforts from earlier today.







I also worked on painting the canopy framework and on most of the flesh and detail work on Herr Wiener Möldy



The flesh tones look more subtle in person

Thanks Bruce. It’s not perfect, but looks good enough. Masks would be an alternative, but I would be terrified of the masks pulling up the original decals. I’ve had too many mishaps of that sort in the past.

I love it!

I did come across this over at scalemates during a search on B-52 Stratofortress kits.




I so do want that kit!