Re: Modelcrazy's bench production 2020
Posted: Tue Sep 08, 2020 8:07 am
It's been some time since an update so here it is.
The Gee Bee is coming along. Sprayed the first coat of white and will wet sand before another soon. I think I have a way for making that integrate red pattern. I copied the instructions to 159%, cut out the red pattern, transferred that to a thin sprue sheet and cut that out. Now if I transfer that mold to some tape, I should be able to use it as a mask for the upper and lower wings. The fuse and wheel pants are another story.
The Apache has stopped production waiting some new decals. It was too light, now it's too green, next hopefully it'll be just right
The Akagi is progressing very slowly. I amd now installing single rungs to the hull ladders. I need to purchase a porthole set to replace the portholes. Here in these pics you can see the guide tape for drilling the holes for the rungs.. I broke multiple 0.3mm drills so I went to a small awl instead. Works better
The Gee Bee is coming along. Sprayed the first coat of white and will wet sand before another soon. I think I have a way for making that integrate red pattern. I copied the instructions to 159%, cut out the red pattern, transferred that to a thin sprue sheet and cut that out. Now if I transfer that mold to some tape, I should be able to use it as a mask for the upper and lower wings. The fuse and wheel pants are another story.
The Apache has stopped production waiting some new decals. It was too light, now it's too green, next hopefully it'll be just right
The Akagi is progressing very slowly. I amd now installing single rungs to the hull ladders. I need to purchase a porthole set to replace the portholes. Here in these pics you can see the guide tape for drilling the holes for the rungs.. I broke multiple 0.3mm drills so I went to a small awl instead. Works better