Page 6 of 6
Re: Gee Bee Racer - Lindberg 1/32
Posted: Sat Jul 25, 2020 5:38 pm
by Floki
It sounds like the needle isn't fully seated if you're getting that much paint. Is it a double action or single?
Re: Gee Bee Racer - Lindberg 1/32
Posted: Sat Jul 25, 2020 7:26 pm
by LyleW
Yes, a Badger 105. The needle is sticking out the end, and it won’t go any further. So, I believe it is fully seated. I believe I had a fine needle in it and was getting a lot of tip dying, so I put this one in. I think it is a larger needle than the one I wanted. I’ll check that out in the next day or two.