SPA Modeler

Much thanks, dudes!


Work is starting to ramp up, thus a little less bench time...but I am starting to get somewhere with the Avenger.

So far...the main/big PE bits...



Top/center...I cut out the rear door, to position it open. This made the door a bit too small. I used that part for the interior side of the door, while the outside was smash-molded over the area for the contour, then cut to shape.

There was zero detail for the radio ops. area....UNACCEPTABLE!!!



I'll be adding a little more after painting.

I hope that you’re gonna pose that hatch open after adding that detail in there

Man that is some great scratch work!

Wow....

Stikpusher wrote:I hope that you’re gonna pose that hatch open after adding that detail in there

There's little windows to look through!!!


Almost time to close things up...



Wired up the engine. Brass rod for the push rods...

Wow that IP! Fantastic work, and in that scale. Looks great.

Beautiful scratch work in the rear compartment and bomb bay! Man your work is always a feast for the eyes!

Jeremy I'm always overwhelmed at the incredible mastery of your work! Beautiful interior!

Stikpusher wrote:Beautiful scratch work in the rear compartment and bomb bay! Man your work is always a feast for the eyes!

You ain't kidding

Thanks again all!
Work season has had me BUSY.
I have managed an hour or two, here and there...and we're gettin somewhere now!





It has since been glossed and will be getting decals tonight!

I really like the 3 tone color scheme.