Beriev Be-2 Amodel 1/72
Posted: Wed Apr 09, 2014 9:45 am
So.. yesterday tried to post the storch resume and fail (my fault.. closed the posting windows after finished to write
) then try with this
box'n'sprues, you know it's a short run





as you can see theres some flash ... just some
A brief resume
After digging works to find the pieces trought the sprues modified the gluing order to keep the engine for last


removable

Original details of cockpit that erased after

adding cockpit details with stretched sprues and electrical cable wires and evergreen sheets





Painted. Used italeri acrilics to allow me to paint in the actual little workbench
not bad these colors with brushes



before to close halves



wings after sanding/orbital sander cure


filled tail trenches

bottom wings and fuselage secured

and filling gaps


removed the wing bumper, not present in the version i'm building


under tension of regular maskin tape

rigging with stretched sprue


paint the bottom (after grey primer , enamel humbrol for external paint) with humbrol 89, 3 thinned layer to get a good surface


omit the light green steps (116 humbrol) and here actual situation
a 91 dark green humbrol darkened with 33 black, also wires painted in black and done a brief drybrush



next step retouches to prepare for final steps
Sorry for the too miuch pictures on a single post
At the next!
box'n'sprues, you know it's a short run





as you can see theres some flash ... just some
A brief resume
After digging works to find the pieces trought the sprues modified the gluing order to keep the engine for last


removable

Original details of cockpit that erased after

adding cockpit details with stretched sprues and electrical cable wires and evergreen sheets





Painted. Used italeri acrilics to allow me to paint in the actual little workbench



before to close halves



wings after sanding/orbital sander cure


filled tail trenches

bottom wings and fuselage secured

and filling gaps


removed the wing bumper, not present in the version i'm building


under tension of regular maskin tape

rigging with stretched sprue


paint the bottom (after grey primer , enamel humbrol for external paint) with humbrol 89, 3 thinned layer to get a good surface


omit the light green steps (116 humbrol) and here actual situation



next step retouches to prepare for final steps
Sorry for the too miuch pictures on a single post
At the next!



