Academy 1/32 Sopwith Camel
Posted: Tue Aug 23, 2016 4:37 am
I can't remember if I mentioned I was building this too, or not. Guess it's that old age combined with summer brain swelter! 
This is my Academy 1/32 Sopwith Camel. This was a struggle for a number of reasons. I tried very hard to use little more than what was in the box. That being said, next time I will use EZ line and my own turnbuckles, add a few pieces of styrene for vision blocks, and probably pin the cabanes, (struts), in place. The holes in the wings supposed to help with alignment were at least 1-2mm larger than the strut. Too much slack, which caused numerous frustrating issues as I attempted to attach upper & lower wings. The alignment of fuselage halves was tolerable, but required some filling and sanding on top to make the seam even.
The only details I added, for the most part, was Uschi wood decals over a red-brown to simulate wood around the cockpit, and a hand carved (by me), prop with scratch built prop hub plate.
I will have to redo the engine shroud, however. Some sort of loss of motor control, a can of compressed air, and a few drops of oil stain made for quite the mess.



And here's the WWI flying ace, waiting to take to the air. Now where's that prop gone off to?
As always, thanks for looking!
This is my Academy 1/32 Sopwith Camel. This was a struggle for a number of reasons. I tried very hard to use little more than what was in the box. That being said, next time I will use EZ line and my own turnbuckles, add a few pieces of styrene for vision blocks, and probably pin the cabanes, (struts), in place. The holes in the wings supposed to help with alignment were at least 1-2mm larger than the strut. Too much slack, which caused numerous frustrating issues as I attempted to attach upper & lower wings. The alignment of fuselage halves was tolerable, but required some filling and sanding on top to make the seam even.
The only details I added, for the most part, was Uschi wood decals over a red-brown to simulate wood around the cockpit, and a hand carved (by me), prop with scratch built prop hub plate.
I will have to redo the engine shroud, however. Some sort of loss of motor control, a can of compressed air, and a few drops of oil stain made for quite the mess.



And here's the WWI flying ace, waiting to take to the air. Now where's that prop gone off to?
As always, thanks for looking!