So... heres the wip:
Starting from fuselage and cockpit, i tried something different, glued fuselage and after insert the cockpit from the front (after a good lead weight)
during the wip changed idea various times , after put the ngine i removed and choose the detailing way, also gued the main roto but i see he basically wrong in lots of aspects , so cut off blades and reshape .
Digging in the engine to have space to insert plastic tubes and a new edge out
opened the side air intake and side detail (i think steps for maintenance )
Added another tube on the engine and stretched sprue along the perimeter (also in the side steps holes)
Also.. as you can see from pictures , rescribbed panel ines
Detailing cockpit:
New commands, notice pedals start
also some improvements at original details
Seats improvements and upper instruments added
now.. the IP, i'll paint intruments on
Next step paint:
Primer and grey
Basic colors on
Details added, washing and basic seat belts with masking tape
Ang glued all in
gears (skids?) and front clear nose (that received blac baint on top borders and glossy clear to seal )
So guys .. omitted some steps just to show a wrong way for final finish with decals..
A pair of wrong clues and shallow looking to instructions make me paint it as late gazelle camo but.. decals was for old scheme
So paint on decals and correct scheme on
I forget about, rear windows are from acetate clear sheet.
then stolen same decals from the other gazzelle ..
More problems.. original shaft is too short
no fear and plastic rod with aluminium details
So heres actual state of works
Asap more
PS.. the rotor basement i lost.. another scratch needed
