SPA Modeler

Well here we go. I went out and bought the Dragon M55 Quad .50 gun yesterday, and today I started it as the "new purchase" build for this GB. I just can't get the motivation up to get restarted on my Weasel, so I figured that a smaller kit will get the mojo flowing again.



Anyways I finished step 1 in about 40 minutes at the bench just now (after cleaning things there up a bit). This is typical Dragon, with lots of tiny beautifully detailed parts. Not shake and bake by any means, but not intimidating either.

Step 1 builds the ammo cans, wheels, support legs, battery, and motor. Now the motor is about 1/2" (12.7mm) in size and has lots of fiddly bits...



Like I said over on the "latest acquisitions" thread, I am building this in tribute to my dad, who crewed on these in Germany in the mid 1950s.

This'll be a really interesting project to watch stik - It's great that you can build a model of something you can actually tie to a photo with your dad.

Thank you Stuart. This should be a good quick build. And I do like the family ties in it.

More progress!!! What a concept...

Step 2 done, the turret base built, minus the PE slip ring for the underside. Not enough time before work to tackle that and any possible speed bumps...

Good start Stik!

Thank you Stuart. I think after I get the PE on later, the hardest parts of assembly are behind me...

Looking great Carlos! It feels great to get something done doesn't it? Also, thanks for posting this; I'd forgotten that I had also started a GAABSA thread until I saw the title of this one! I just updated mine with a couple weeks worth of work.

Looking forward to seeing more...

Thanks Mark. Yes it feels damn good to be rolling forward again. I got the PE ring glued on yesterday, and started on the gun mounts as well. But only one of four yesterday. This is typical Dragon. Why mold it in one piece when we can do it in three or five! Yes it makes for better detail, but...

I think tomorrow will see some major progress.

Stikpusher wrote:This is typical Dragon. Why mold it in one piece when we can do it in three or five! Yes it makes for better detail, but...

Sounds like Modelcollect as well. Must be a Chinese modeler thing......

Looking forward to seeing the new progress.

Well here is the PE ring glued onto the base of the turret





then it was time to build the gun mounts and guns... very nice .50s with hollow molded bores... saved me a step of drilling them out...