1/72 Dragon P-61Finished
Posted: Wed Nov 01, 2017 1:11 pm
As can be seen...this will not be simply OOB!!!
Stay tuned...this will be a fun ride!
As can be seen...this will not be simply OOB!!!
Stay tuned...this will be a fun ride!
Page 1 of 6
As can be seen...this will not be simply OOB!!!
Stay tuned...this will be a fun ride!
Re: 1/72 Dragon P-61
Posted: Wed Nov 01, 2017 2:18 pm
Subscribed here as well. You seem happier to be working in 1/72 surrounded by lots of AM. Just saying. I remember the pair of Eduard 1:72 FW 190s you built with all the engine detailing as though it was yesterday, so this will be a treat. Best of luck.
Re: 1/72 Dragon P-61
Posted: Thu Nov 02, 2017 3:11 am
Ooh I get to watch in two places 
Re: 1/72 Dragon P-61
Posted: Thu Nov 02, 2017 9:29 am
This one is going to be loaded. Always a treat to watch a build with lots of aftermarket pieces... you just never know how it will all turn out! Given your skills, I'm sure it is going to be a beautiful result.
Re: 1/72 Dragon P-61
Posted: Thu Nov 02, 2017 10:53 am
Hmmm... lotsa goodies. Following this one....
Re: 1/72 Dragon P-61
Posted: Thu Nov 02, 2017 3:16 pm
I can't help but follow a Fermis build. They are always a treat. I do hope this won't come to the Phoenix Nationals though; I need some small hope that I'll be able to place....
Bring it on Fermis!
Bring it on Fermis!
Re: 1/72 Dragon P-61
Posted: Fri Nov 03, 2017 7:06 am
This should be recorded and put on some sort of video outlet. Going to be good!
Re: 1/72 Dragon P-61
Posted: Sat Nov 04, 2017 1:21 am
I want more. I can't wait to see what you do with all of this!
Re: 1/72 Dragon P-61
Posted: Sat Nov 11, 2017 6:59 pm
Alright, gentlemen...here we go!
Gettin somewhere with this one, finally!
Interior is finished up...used some kit parts, some from the resin set and some from the PE sets, and scratched up new gun barrels with aluminum tubing...
I added some lead sheet to the bottom of the floor, just aft of the gear bay, as well as a little on the rear bulkhead. I'm sure I'll need to add more between the IP and radar.
Gettin somewhere with this one, finally!
Interior is finished up...used some kit parts, some from the resin set and some from the PE sets, and scratched up new gun barrels with aluminum tubing...
I added some lead sheet to the bottom of the floor, just aft of the gear bay, as well as a little on the rear bulkhead. I'm sure I'll need to add more between the IP and radar.
Re: 1/72 Dragon P-61
Posted: Mon Nov 13, 2017 11:26 am
The interior looks real good!