Allison PT-6 1/10 scale from Atlantis
Posted: Sat Jan 04, 2020 9:53 am
I fully and completely lay the blame for this purchase on the collective feet of this forum! Well, that and I used the 40% off coupon at HL. Anyway, I have started trying to "catalog" the kits as I buy or start them...scanning the instructions, decals, etc. Here it is. Parts count is 240. It does "operate" by hand rotation of a knob at the rear of the engine. Propeller blades will also change pitch by rotating a section of the tip of the spinner. Ugly plastic colors, though.
As these types of kits do, there is an informational/history of the PT-6 included.
And the sprues, still in the bags. When I open them, if there is interest, I will take some pictures of the sprues.
And, yes, there are even a few decals!
Not too crazy about their style of doing the instructions...way too busy for my taste. I'll get some .jpgs of them later. Apparently, even 400 dpi creates a fjile too large for PostImg to handle, by just enough.
As these types of kits do, there is an informational/history of the PT-6 included.
And the sprues, still in the bags. When I open them, if there is interest, I will take some pictures of the sprues.
And, yes, there are even a few decals!
Not too crazy about their style of doing the instructions...way too busy for my taste. I'll get some .jpgs of them later. Apparently, even 400 dpi creates a fjile too large for PostImg to handle, by just enough.
Especially four of them...
