Page 1 of 2
1/350 Pitroad JMSDF Yushio
Posted: Sun Jan 24, 2021 11:45 pm
by Scruffy
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 7:33 am
by LyleW
Cool. So, how big is that rascal?
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 8:17 am
by Floki
Really cool looking
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 8:56 am
by Medicman71
Very nice!
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 10:43 am
by Stikpusher
Good looking build Scruffy! Ya gotta love those 1/350 modern sub kits!
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 3:17 pm
by Duke Maddog
Nicely done! Way to go on that Ernie!
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 7:52 pm
by BlackSheep214
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 7:57 pm
by Scruffy
LyleW wrote:Cool. So, how big is that rascal?
It is about 8" or 9" OAL.
Thank you for all the comments guys, much appreciated.
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 8:00 pm
by keavdog
Very nice. I really like the placard - how did you do that? Been ages since I built a sub.
Re: 1/350 Pitroad JMSDF Yushio
Posted: Mon Jan 25, 2021 8:58 pm
by Scruffy
Really, really simply!
The base board is (somewhat appropriately) Cherry that I routed an edge on and then polyurethaned. The placard is simply from the header of the painting guide in the kit, which was printed on nice glossy stock. I simply cut it out and affixed it to a piece of .015 sheet with double sided tape and used a Sharpie to blend the edges of the plastic sheet!