I cleaned and reorganized my work area today so it's time for some pictures. The table is a plywood bench with a layer of Celotex, and then plate glass over that. Easy to clean up paint or glue messes with a single edge razor blade and Windex or lacquer thinner. I put paper towels down in the area I work (usually the normal 2 square feet!
). The area to the right of the second photo is where I build R/C models. The photo backdrop comes down easily when I don't need it but I try to not do both types of construction at the same time due to dust. The filter on the wall is covering a large exhaust fan, and when I paint I run that and the A/C in the window in fan mode which gives a good cross flow. All the lights in the workshop are 5000 Kelvin except the one above the bench, I turn it off when I'm taking photos.
