Before I paint the rest of the Neutral Grey undersides, I want to get the top ready for paint. That means I need to get the windscreen on so that I can check/fix the joint. First, I tried to glue the gun sight assembly in-place so that I could get some last shots of the cockpit area before it starts getting closed up.







But it was difficult to get the pin on the windscreen into the hole of the gun sight assembly. So I had to remove it and glue the assembly into the windscreen BEFORE the whole thing gets glued onto the fuselage. The port side fits almost perfectly.


The starboard side has an ever so slight gap. I recognized this during pre-fitting so only the port side has been fused with glue. I'll wait until that bond dries before I try to gently coax the starboard side gap shut.

And yes, I notice the paint mismatch spot on the rear quarter panel on the port side. I'll fix that shortly!




















