I'd walk 2.29 miles for that camel.
Is that rigging stretched sprue?m
Is that a Camel and DH.2 in your pocket?!
Re: Is that a Camel in your pocket?!
This stuff is so frustrating, I really had no desire to rig the whole thing at one time. Nice to have the majority out of the way!Duke Maddog wrote:Awesome job on that DH-2! I also built one of those in 1/72 scale, but I rigged mine after it was fully assembled. It was pretty tricky in some places, but I managed to get it done. I don't think mine is as clean as yours though.
Re: Is that a Camel in your pocket?!
Yup, all stretched sprue.Manny1943 wrote:I'd walk 2.29 miles for that camel.
Is that rigging stretched sprue?m
I cut each piece a bit long and CA one end where it goes...let it set a minute, trim the other end close, but still just a touch long and CA that end.
For the Camel, I put all in place...rigging was still "loose"...I held the whole model about 12" above a candle, the rising heat tightened the sprue up real nice.
Tried that with the DH-2...it took care of a few...a few got too hot and had to be replaced...I finished off the rest that were still loose, by holding an old exacto blade in the candle flame then held it under each "wire" till they tightened up.
-
Stikpusher
- Moderator
- Posts: 21188
- Joined: Sat Apr 05, 2014 8:37 pm
- Location: Ceti Alpha 5
Re: Is that a Camel in your pocket?!
That sounds like an easy enough method, if time consuming, to rig up a bipe... Thanks for the quick how to Fermis.
"Surely I have made my meaning plain? I intend to avenge myself upon you, Admiral. I have deprived your ship of power, and when I swing 'round, I intend to deprive you of your life."
FLSM
FLSM
Re: Is that a Camel in your pocket?!
I love your camel and want to see its toe...Stikpusher wrote:That sounds like an easy enough method, if time consuming, to rig up a bipe... Thanks for the quick how to Fermis.
Re: Is that a Camel in your pocket?!
Manny1943 wrote: I love your camel and want to see its toe...
...I should have seen that one coming!!!
Re: Is that a Camel in your pocket?!
Fermis that is some nice work.
Heh, I've missed that.
Manny1943 wrote:I love your camel and want to see its toe...Stikpusher wrote:That sounds like an easy enough method, if time consuming, to rig up a bipe... Thanks for the quick how to Fermis.
Heh, I've missed that.
-
lawdog114
- Master Member
- Posts: 534
- Joined: Tue May 20, 2014 11:46 pm
- Location: Olmsted Township, Ohio
Re: Is that a Camel in your pocket?!
CallSignOWL wrote:rigging is what scares me away fome bipes....
Excellent work...Joe
Can you fly this plane and land it? Surely you can't be serious? I am serious, and don't call me Shirley
Re: Is that a Camel in your pocket?!
Hmmmm...these pics still have me intrigued...Fermis wrote:Thanks guys!
Borg...the only thing extra I did on this was the rigging and replaced the tail skid.
I really wasn't intending on rigging it, but figured it would be good practice for this one....
Eduards 1/72 Airco DH-2
Main structural rigging for wings is done. Figured it'd be a lot easy to knock these ones out before installing the tail.
