Revell H-291 by speedgraflex

[speedgraflex]

I see similarities between the way K-2SO and Kryten were "built" as characters, with subsequent similarities in scenes where the bots are taught how to lie, cheat, etc.! Great advice!

[Stikpusher]

K2SO is like a droid version of Spock with a dark British sense of humor.

[speedgraflex]

That's an excellent way to describe him, Carlos!!

[Stikpusher]

K2SO is like a droid version of Spock with a dark British sense of humor.

That's an excellent way to describe him, Carlos!!

[speedgraflex]

Now this was a fun movie!

[Medicman71]

It’s a Sopwith Camel flown by the RAF Major William Barker who managed somehow to keep the same aircraft through his military career. This represents the aircraft following a rebuild of new wings and motor following a takeoff or landing crash on the field. Barker was uninjured but the aircraft was seriously hurt and was rebuilt. At the time personal markings and a red devil hood ornament were added!



Crash photo

SIR!! You can't park there!!!

[speedgraflex]

Hahaha! I know it’s kind of a strange situation at the very least. That’s the pilot and he looks hale and healthy and his plane is completely wrecked. I should look up what happened here. Camels were notorious for being very hard to maneuver off the ground, on the ground. Thanks, Mike!

[mustang1989]

Not at all, Stuart. Not at all. I did actually pick this up last night and looked at it, which is about all I’ve had time to do with this project for two weeks.

Now that's a feeling that I'm all too familiar with Bruce. I have, however, managed to get back to the bench this past week. I'm busier than a long tailed cat in a room full of rocking chairs lately.

Hang with it brother. Looking forward to seeing more on this one.

[speedgraflex]

Thanks, Joe! It’s been a real bear these past few weeks with everything packed except the fuselage and cockpit module. I have a compound curve to form which partially encloses the upper deck and I’m not quite sure how to address technically.

I’m thinking I’ll make a sub form as a support then use epoxy putty to create the final finish.

[Stuart]

Sopwith's were a handful anywhere lol! That's why a lot of pilots preferred the SE5a.