1/48 Italeri Tornado F.3 ADV

Medicman71 · Post by **Medicman71** » Thu Apr 02, 2015 2:51 pm

mostrich wrote:Up to a fast and impressive start.

Following...

Thanks Mostrich!

Medicman71 · Post by **Medicman71** » Thu Apr 02, 2015 3:11 pm

The canopies fit perfectly. No issues there at all. They're not glued in yet.

nathant · Post by **nathant** » Thu Apr 02, 2015 4:38 pm

Excellent fit of the parts! No filler used yet?

Medicman71 · Post by **Medicman71** » Thu Apr 02, 2015 5:09 pm

Thanks guys. There's some areas that are gonna need some filler and sanding. Especially on the bottom at the front. The intakes are gonna need a lot of work as well.

CallSignOWL · Post by **CallSignOWL** » Thu Apr 02, 2015 5:50 pm

I like that red tail, too.

great job on teh pit.

is the nose/fuse assembly just a butt join or are there tabs that slot into place?

Post by **Stikpusher** » Fri Apr 03, 2015 11:19 am

Looking real good so far Doc!

Bish · Post by **Bish** » Sun Apr 05, 2015 11:56 am

Great to see a Tornado being built, nice work so far, and a good choice of scheme.

Medicman71 · Post by **Medicman71** » Mon Apr 06, 2015 12:27 pm

Thanks all!

@Owl- There's tabs at the bottom but they don't help much.

I always try and find a special scheme, CAG jet, or something different so that it's not just a grey jet.

Medicman71 · Post by **Medicman71** » Mon Apr 06, 2015 12:28 pm

Intakes are done. Just need to clean them up.

SPA Modeler

1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV

Re: 1/48 Italeri Tornado F.3 ADV