Tom......LOL!
I was at the point the other day to where I was going to install those inner wheel wells that I had been working on a couple of months ago and the suckers wouldn't fit. All that work to them and the body could not be installed with them in place. I had pondered the idea of leaving them out but that looked cheap and unfinished. The initial thoughts to remedy this started here....
Followed by some action with cutting out a part that resembled the plastic piece except only from the firewall forward.
So far I'm liking the results. In the foreground you can see what the lack of the inner fender wells makes the engine compartment look like and the update on my "test mule". (This is the same blue body that I started out with. I stripped most of the blue off it with brake fluid)
I managed to get the R/H side cut out and formed this morning. More shots with the test mule...
Now I'm at the point to where I don't know if I want to Alclad them or cover the inner sides with Chrome BMF. I still have some learning to go with Chrome Alclad......we'll see.....
