Page 3 of 4
Re: P-51 D 10NA Tamiya 1/32
Posted: Thu Jun 04, 2015 4:12 pm
by Duke Maddog
Re: P-51 D 10NA Tamiya 1/32
Posted: Mon Jun 08, 2015 7:46 am
by ajcmac
Thanks Duke
.
It is in fact amazing in terms of fit. After three sets mounted in separate air ducts underneath the radiator and the engine and it fits without fail. Cockpit, engine and rear air ducts and air ducts under the engine nothing was pasted. However fittings without fail.
And finally the fuselage, glued.
I started the wear on the propeller.
Air ducts under the engine.
Regards
ajcmac
Re: P-51 D 10NA Tamiya 1/32
Posted: Mon Jun 08, 2015 9:47 am
by CallSignOWL
Beautifully done! Is all that detail right from the box?
Re: P-51 D 10NA Tamiya 1/32
Posted: Mon Jun 08, 2015 11:53 am
by Thomas_M
Wonderful work! Love the subtle wear on the propeller!
Re: P-51 D 10NA Tamiya 1/32
Posted: Mon Jun 08, 2015 2:20 pm
by Manny1943
Loads of detail on this MOFO. Looking good.
Re: P-51 D 10NA Tamiya 1/32
Posted: Tue Jun 09, 2015 1:45 pm
by Medicman71
Such incredible work!!
Re: P-51 D 10NA Tamiya 1/32
Posted: Wed Jun 10, 2015 4:33 am
by Stuart
Very very very nice
Re: P-51 D 10NA Tamiya 1/32
Posted: Fri Jun 12, 2015 6:03 am
by ajcmac
Thanks you for your words
.
CallSignOWL wrote:Beautifully done! Is all that detail right from the box?
CallSignOWL is OOB.
Engine compartment and engine all set.
Regards
ajcmac
Re: P-51 D 10NA Tamiya 1/32
Posted: Fri Jun 12, 2015 6:58 am
by BlackSheep214
Wow! Very nice work!
Re: P-51 D 10NA Tamiya 1/32
Posted: Wed Jun 17, 2015 8:57 am
by ajcmac
BlackSheep214 wrote:Wow! Very nice work!
Thank you. I'm glad you're enjoying it.
I completed the flaps and ailerons.
Horizontal stabilizers.
The rudder.
I started the construction of the landing gear.
Finally I glued the wings to the fuselage.
Regards
ajcmac