Back on track… I have a tendency to assemble stuff out of step or skip on certain spots but instead glue to canopy. Example…roof nd inside column are to be assembled to cockpit area. Nope… I gotta do things the hard way/easy way. I glued the columns inside the chopper walls, the roof on one half of chopper body.
I opt to have the rotor engine door closed. I made some shims using very thin sheet pieces of styrene to help glue it flushed. Didn’t think whether it will interfere with gluing the body halves together. Testing whether it does or not… yeah a little bit but I think I can make it work.
Now what’s happened so far… tried to close up the chopper bodies together only to find some fit issues (most likely from my stupidity

). Right now, I use thin CA a glue to close up the nose end first. Then, I’ll proceed with top and bottom body areas. So I figure, let me work slowly; glue little sections at a time using CA glue. Once the main body halves are done, the tail part shouldn’t be an issue.
I’m leaving off the rotor motor/blade install until last. I can’t risk breaking off delicate parts.