P-51 D 10NA Tamiya 1/32
-
Duke Maddog
- Elite Member
- Posts: 7668
- Joined: Tue Jun 03, 2014 11:22 am
- Location: Rowland Heights, CA
Re: P-51 D 10NA Tamiya 1/32
Stunning work Mac! I bow to the Master.
The Duke
Virtuoso of Miniatures
"Do you know what the chain of command is? It's the chain I get and beat you with 'till you understand who's in ruttin' command!"
-Jayne Cobb, Firefly Episode 2 "The Train Job"
We are modelers - the same in spirit, in hunger to insanely buy newly released kits, hustlers in hiding our stash from our better halves and experts in using garbage as replacements for after-market parts.
Virtuoso of Miniatures
"Do you know what the chain of command is? It's the chain I get and beat you with 'till you understand who's in ruttin' command!"
-Jayne Cobb, Firefly Episode 2 "The Train Job"
We are modelers - the same in spirit, in hunger to insanely buy newly released kits, hustlers in hiding our stash from our better halves and experts in using garbage as replacements for after-market parts.
Re: P-51 D 10NA Tamiya 1/32
Thanks DukeDuke Maddog wrote:Stunning work Mac! I bow to the Master.
.It is in fact amazing in terms of fit. After three sets mounted in separate air ducts underneath the radiator and the engine and it fits without fail. Cockpit, engine and rear air ducts and air ducts under the engine nothing was pasted. However fittings without fail.
And finally the fuselage, glued.
I started the wear on the propeller.
Air ducts under the engine.
Regards
ajcmac
-
CallSignOWL
- Addicted Member
- Posts: 1754
- Joined: Mon Apr 07, 2014 12:45 pm
Re: P-51 D 10NA Tamiya 1/32
Beautifully done! Is all that detail right from the box?
Every take-off has a landing...some are just better than others
-
Thomas_M
- Admin
- Posts: 4244
- Joined: Fri Dec 13, 2013 9:43 am
- Location: Bad Wurzach - Germany
- Contact:
Re: P-51 D 10NA Tamiya 1/32
Wonderful work! Love the subtle wear on the propeller!
Re: P-51 D 10NA Tamiya 1/32
Loads of detail on this MOFO. Looking good. 
-
Medicman71
- Elite Member
- Posts: 11299
- Joined: Mon Apr 07, 2014 9:32 am
- Location: Houston, Tx
Re: P-51 D 10NA Tamiya 1/32
Such incredible work!! 
Mike
Sponsored by Boeing, Lockheed Martin, Northrop Grumman, Saab, BAE, and Dassault
Sponsored by Boeing, Lockheed Martin, Northrop Grumman, Saab, BAE, and Dassault
Re: P-51 D 10NA Tamiya 1/32
Very very very nice
Stuart Templeton 'I may not be good but I'm slow...'
Re: P-51 D 10NA Tamiya 1/32
Thanks you for your words 
.
Engine compartment and engine all set.
Regards
ajcmac
.CallSignOWL is OOB.CallSignOWL wrote:Beautifully done! Is all that detail right from the box?
Engine compartment and engine all set.
Regards
ajcmac
-
BlackSheep214
- Elite Member
- Posts: 13417
- Joined: Sun Apr 06, 2014 8:47 pm
Re: P-51 D 10NA Tamiya 1/32
Wow! Very nice work!
“Who controls the skies, controls the fate of this Earth”
Author unknown- 352nd Fighter Group, Blue-Nosed Bastards of Bodney
“Send one plane it’s a sortie; send two planes it’s a flight; send four planes it’s a test of airpower. - Richard Kohn
Author unknown- 352nd Fighter Group, Blue-Nosed Bastards of Bodney
“Send one plane it’s a sortie; send two planes it’s a flight; send four planes it’s a test of airpower. - Richard Kohn
Re: P-51 D 10NA Tamiya 1/32
Thank you. I'm glad you're enjoying it.BlackSheep214 wrote:Wow! Very nice work!
I completed the flaps and ailerons.
Horizontal stabilizers.
The rudder.
I started the construction of the landing gear.
Finally I glued the wings to the fuselage.
Regards
ajcmac